Atas Permashake II Manuel d'utilisateur télécharger pdf (Page 3)

Hip & Ridge Detail

Valley Detail

Hip and ridge applications are handled in

the same manner.

1. Install roof panels to meet at hip or

ridge. (Depending on roof geometry

and run of roof, the top panel may have

to be cut along the length of panel.)

2. Lay a 6” strip of closure tape across

panels at hip/ridge line.

3. Lay cap on roof and secure the cap

with clips and screws, (2) per piece.

Ridge caps can accommodate standard

ridge venting products. Refer to venting

manufacturer's instructions and local

building code requirements.

Note: For hip applications, fasten the caps

with clips at the high point on the shingle

in order to avoid dimpling, and make sure

the clip and screw penetrates the cap

through the closure into the solid

substrate.

1. Install self-adhered roofing underlayment

18” up both sides of the valley line.

2. Install the valley pan and clip fasten

through the substrate at 24” o.c.

3. Measure required panel to length to come

within 3” of center of valley.

4. Cut and fold panel on diagonal to create a

solid end and fasten with stainless steel color

matched pop rivet to hold in place.

5. Lay shingles onto the valley pan

maintaining at least 3” clearance from the

valley’s center and fasten with clips outside

the valley pan.

CUT AND FOLD PANEL EDGE

IN VALLEY TO CLOSE END.

POP RIVET

SELF-ADHERED ROOFING

UNDERLAYMENT

VALLEY PAN

UNDERLAYMENT

ANCHOR CLIP

1 ½" WAFER HEAD SCREW



PERMASHAKE II PANEL

RIDGE CAP BENT TO

REQUIRED ANGLE AND TWO

INTERLOCKING TABS BENT UP

FOR CLIP ATTACHMENT.

(HIP CAP SIMILAR)

LOCATE CLIPS HERE

SHORT RIDGE

CAP PIECES

CHANNEL TRIM

PERMASHAKE II PANEL

PREVAILING WIND

DIRECTION

LAP

START APPLYING

RIDGE CAP SHINGLE

AT THIS END

SHORT HIP CAP PIECES

PANELS CUT

TO MEET AT

HIP LINE

HIP LINE

UNDERLAYMEN

T

1

Exterior grade #10-16 x 1 ½” wafer head screw

2

#10 x 2” long gimlet point screw with 5/16” cast zinc color matched hex washer head and EPDM washer

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire