Atas Permashake II Manuel d'utilisateur télécharger pdf

Installation Guide

ATAS International, Inc.

www.atas.com/permashakeII

484.221.6375

Review and understand complete guide before beginning

installation. This guide has been prepared as suggested

details to particular design conditions. Each condition has

certain limitations to performance, aesthetics or economics.

Professionals qualified to assess this information for a

specific project should determine that the selection and

installation are made to their requirements.

ATAS cannot assume any responsibility for the actual

selection, use and/or installation of materials. The panels,

flashings and trim shown in the guide, illustrated over a

solid and plumb substrate, assume that the structure has

been designed and prepared in accordance with local

building codes. Care should be taken during installation

not to damage panels and finish. May void product

warranty.

PANEL INSTALLATION - In environments where ice and

water may dam, apply self-adhered roong underlayment in

accordance with local building codes. Then apply appropriate

underlayment over balance of roof. Snap a vertical and

horizontal line to square up the plane with the eave. Start

at the bottom left hand corner of the roof plane with a full

length panel. Install shingles in a left to right manner from

eave to ridge. See right for stagger method of installation.

Fasten panels to solid substrate with galvanized steel clips.

Manufacturer recommends the use of exterior grade #10-16 x

1 ½” wafer head screws.

CHANNEL TRIM

STAGGER METHOD

Each course 12” to the left of the lower course.

TOP CLIPS

SIDE CLIP

4 ½”

9”

9” 9” 4 ½”

12”

36”

2”

Published panel width dimensions are to be considered as

nominal dimensions. Variations in overall coverage may

occur at installation due to typical manipulation of panels

during attachment to the roof assembly.

Permashake II panels are simulated wood shakes

manufactured from 29 gauge steel with a Kynar 500® PVDF

or Hylar 5000® PVDF nish. They are available in 6 colors.

Panel coverage is 12” x 36”. Minimum recommended roof

pitch is 4:12.

There are twelve (12) Permashake II panels packaged per

carton. Approximately thirty-four (34) panels equal a square.

Panels are always installed left to right and should have a

minimum of four (4) top anchor clips and one (1) side anchor

clip.

1 2 3 4

Résumé du contenu

Page 1 - Installation Guide

Installation GuideATAS International, Inc. www.atas.com/permashakeII 484.221.6375Review and understand complete guide before beginning installation.

Page 2 - Gable Detail

Eave DetailHeadwall DetailGable Detail1. When applying a re-roof application, cut back existing shingles and drip edge as required to apply appropriat

Page 3 - Valley Detail

Hip & Ridge DetailValley DetailHip and ridge applications are handled in the same manner.1. Install roof panels to meet at hip or ridge. (Dependi

Page 4 - Shed Ridge Detail

Tools and Rules:Basic Equipment Required:Tie-off ropes, safety harness, long level, ladders, scaffolding with approved planking, extension cords with

Commentaires sur ces manuels

Pas de commentaire

Atas Permashake II Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la maison Atas Permashake II. ATAS Permashake II User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Atas Permashake II